Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REMOTE CONTROL
SELF-CLEAN function
Only optional for some heating pump inverter
appliance.
To active this function, turn off the indoor unit
at first, then press
then you will hear a beep,
appear on the indoor LED, and
appear on the remote display .
1. This function helps carry away the accumulated
dirt, bacteria, etc from the indoor evaporator.
2. This function will run about 30 minutes, and it
will return to the pre-setting mode. You can
press
button to cancel this function during
the process.
You will hear 2 beeps when it's finished or
cancelled.
It's normal if there is some noise during this
function process, as plastic materials expand
with heat and contract with cold.
We suggest operating this function at the
following ambient conditions to avoid certain
safety protection features.
Indoor unit
Temp < 86 F (30 C)
Outdoor unit
41 F (5 C) < Temp < 86 F (30 C)
It's suggested to utilize this function every
3 months.
o
8 heating function (Optional)
C
1. Long press ECO button over 3 seconds to active
this function, and
8 C
the remote display.
Do it again to deactivate this function.
2. This function will auto start the heating mode
when the room temperature is lower than 8 C
o
(46 F), and it will return to standby if the
temperature reaches 9 C (48 F).
3. If the room temperature is higher than 18 C
o
(64 F), the appliance will cancel this function
automatically.
(Optional)
CLEAN
button
AC
will
will
o
o
o
o
o
o
o
(
46 F
) will appear on
o
o
Gentle Wind function (Optional)
1. Turn on the indoor unit, and change to COOL
mode, then press GENTLE WIND button or
long press FAN and MUTE button together
3 seconds to active this function,
appear on the display.
Do it again to deactivate it.
2. This function will auto close the vertical flaps,
and give you the comfortable gentle wind feeling.
Health function
1. Turn on the indoor unit at first, press HEALTH
to active this function,
display.
Do it again to deactivate it.
2. When the HEALTH function is initiated, the
Ionizer/ Plasma/ Bipolar Ionizer/ UVC Lights
(depending on models) will be energized and
running.
o
ANTI-MILDEW function (Optional)
ANTI-
MILDEW
ANTI-
Press
MILDEW
function,
will appear on the display. Do it again
o
to deactivate this function. After running COOL/
DRY for more than 30 minutes, you can operate
this function, the unit will blow airflow for about
15 minutes to dry the inner parts to avoid mildew,
o
then shuts off the unit.
Note: ANTI-MILDEW function only available in
DRY/COOLING mode.
36
(Optional)
will appear on the
button to activate the ANTI-MILDEW
will
Werbung
