Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REMOTE CONTROL
Replacement of Batteries
Remove the battery cover plate from the rear of the remote control, by sliding it in direction as
the arrow.
Install the batteries according the direction (+ and -)shown on the Remote Control.
Reinstall the battery cover by sliding it into place.
Use 2 pieces LRO3 AAA (1.5V) batteries.
Do not use rechargeable batteries.
Replace the old batteries with new ones of the same
type when the display is no longer legible.
Do not dispose batteries as unsorted municipal waste.
Collection of such waste separately for special
treatment is necessary.
For some models, each time when insert the batteries in the remote controller for the first time,
you can set the Cooling only or Heating pump control type. As soon as you insert the batteries,
turn off the remote controller, and operate as below.
1. Long press the MODE button, until the (
2. Long press the MODE button, until the (
Note: If you set the remote control in cooling mode, it will not be possible to activate the
heating function in units with a heating pump. If you need to reset, take out the
batteries and install again.
For some models of the remote controller, you can program the temperature display between
o
o
C and F.
1. Press and hold the TURBO button over 5 seconds to get into the change mode;
2. Press and hold the TURBO button, until it switch to C and F;
3. Then release the pressing and wait for 5 seconds, the function will be selected.
Note:
1. Direct the remote control toward the Air conditioner.
2. Check that there are no objects between the remote control and the Signal receptor in the
indoor unit.
3. Never leave the remote control exposed to the rays of the sun.
4. Keep the remote control at a distance of at least 1m from the television or other electrical
appliances.
) icon flash, to set the Cooling only type.
) icon flash, to set the Heating pump type.
o
o
32
Werbung
