Herunterladen Diese Seite drucken

Falcon Excel FSD 110 Dual Fuel Gebrauchs-, Installations- Und Wartungsanleitung Seite 50

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

English
A clearance of 130mm is required if the cooker is near a corner of
the kitchen to allow the oven doors to open. The actual opening
of the doors is slightly less but this allows for some protection of
your hand as you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly in
front of the place it is to be installed (unless it will not fi t through
a door in its outer packaging).
Cut the banding straps and lift the cardboard box off the cooker,
leaving the cooker standing on the base packaging. See the loose
unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure that
the fl oor covering is fi rmly fi xed, or removed to prevent it being
disturbed when moving the cooker around. You will need the
levelling tool.
From the back tilt the cooker forward and remove the rear half of
the polystyrene base pack.
Repeat from the front and remove the front half of the poly base.
Find the 3 adjusting nuts at the base of the front of the cooker.
These lower the rollers from their storage positions.
The centre adjuster controls the central front roller, the outer 2
controls the rear rollers
All manuals and user guides at all-guides.com
Conversion to another gas
50
Fit the levelling tool to each adjusting nut in turn and lower the
rollers by making 10 complete (360º) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower all three rollers.
Unfold the rear edge of pack base tray.
Open the grill door and Slow oven door. With your hands under
the bottom edge of the hot plate facia, lift the front of the cooker
slightly and then roll the cooker on the rollers.
.
Unfold the rear edge of pack
base tray. Carefully push the
cooker backwards out of the
base pack. Push the cooker
close to its fi nal position,
leaving just enough space to
get behind it.
Take care not to twist it within the gap between the kitchen units
as damage may occur to the cooker or the units.
If the appliance is to be converted to another gas do the
conversion at this point.

Werbung

loading