Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Power failure
In the event of a power failure, the control remembers the temperature setting and
restarts the cabinet when power is restored. If the power failure persists for some time,
the control might revert to the factory setting.
Cleaning
Always disconnect the cabinet before cleaning.
Do not flush compressor compartment and evaporator with water as this may cause
short-circuits in the electrical system.
The cabinet should be cleaned internally with a mild soap solution at suitable intervals
and checked thoroughly before it is put into operation again.
For the external maintenance – use stainless steel polish.
Cleansing agents containing chlorine or compounds of chlorine as well as
other corrosive means, may not be used, as they might cause corrosion to the stainless
panels of the cabinet and the evaporator system.
The compressor compartment and in particular the condenser must be kept free from
dust and dirt. This is best done with a vacuum cleaner and a brush.
The air filters on the condenser and the front panel can be removed and cleaned in a
dishwasher at max. 50°C.
Service
The refrigerating system and the hermetically sealed compressor require no
maintainance. However the condenser and air filter requires regular cleaning.
If refrigeration fails, first look to see whether the cabinet has been unintentionally
switched off, or whether a fuse has blown. If the cause of failure cannot be found,
contact your supplier quoting TYPE, PART NO and SER. NO of the cabinet. This
information can be found on the nameplate.
76-504-1245
23
Werbung
