Werbung
TROUBLESHOOTING GUIDE
English
if you have followed the instructions contained in this manual but have difficulty in operating your unit, locate the SYMPTOM in the left column below.
Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to identify and remedy the problem.
SYMPTOM
eNO power. nee
POSSIBLE CAUSE
The power cord is not connected...
CORRECTIVE ACTION |
The:POWER: button. has been pressed to turn:
the power off.
:
» Playback picture is noisy.
The CHANNEL selector on the TV
i is not set to
the proper channel.
The TV is not fine-tuned correcily.
The connecting cords are not inserted firmly.
The video head is dirty:
The tracking:is not adjusted.
4
a
Connect the power cory to the AC: outlet,
Press the POWE
Set to:the TV channel for the unit.
Fine tune your TV.:""
Check'the connections."
Clean the-video head.
Set the AUTO TRACKING selectorto ON, or set
itto OFF/MANUAL and adjust.the tracking using
the
-TRACKING, —/+" buttons. on. the. re-
mote.control unit.
The playback picture is abnormal.
_No playback picture
'The cassette, cannot be.loaded and i is
'ejected.
The color system setting for the recording was
incorrect.
Set the color system correctly with the SYSTEM
button and record again.
A TV receiver whose color system is incom-
| patible with this unit is connected.
Connect the unit to.a TV receiver whose color
system is compatible. with this. unit: :
The CONVERTER
OUT. switch is not set cor-
rectly.
The: CHANNEL selector on the TV is not set to
the proper channel.
The tape is twisted or tangled in the cassette.
RECs
:
Abnormal operation
Set the CONVERTER OUT switch aT
Set to the TV channel for the unit...
Check the tape...
External noise has affected the built-in micro-
processor.
Disconnect the power cord from: the AC outlet.
Connect it again. after a while and pperate the
On-the-air TV programs cannot be seen.
The cassette is lected when RECORD is
pressed.
"No remote control operation
Connections are not correctly made.
Check the.connections.
unit.
This unit is turned on.
Press:the POWER button to turn off.the unit.
The erasure
prevention tab.on the cassette
has been removed.
Put cellophane tape over the tab:opening...
«
Weak batteries
Replace the batteries with new ones. oe
The playback picture may be blurred or noisy
while the TV program received is clear. Dirt
accumulated on the head after long periods of
use causes this problem.
In this case, clean
the video head using a commercially available
video head cleaning tape.
When the cabinet has become dirty or stained,
dip a piece of gauze or soft cloth into a dilute
solution of neutral cleanser and wipe clean.
Never use thinners or benzine since they will
damage the surface of the cabinet.
1. To maintain the optimum performance of
this unit, regular periodic maintenance is
required.
Your dealer will advise you fur-
ther.
2. Maintenance and adjustments should not
be carried out by the user. In all cases of
difficulty or doubt, consult your dealer,
NOTE ON CONDENSATION
Moisture condensation may occur inside the unit when iti is moved from a cold place to a warm place, after heating a Gold room, ot under conditions
OF high humidity. If the tape is played back under these conditions, the unit and the tape may be damaged. Do not use the unit until it has. warmed
to''room:temperature and the moisture has evaporated completely in a well-ventilated area.
:
Normal operation should be possible usually after two hours.
22
Werbung
