Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ATTENTION
► The sealing strip remains hot after use. Wait a few minutes until the strip has cooled
before cleaning.
► Clean the unit after every use as soon as it has cooled. Leaving the unit uncleaned for
long periods can make it very difficult to remove leftover food and grime and may even
damage the unit.
► If moisture penetrates the unit's housing, it can damage the electronic components.
Please ensure that no moisture enters the device.
► Do not use any harsh or abrasive cleaning agents. Do not attempt to scrape off
stubborn grime with hard or abrasive tools.
► Dry all parts thoroughly before using after cleaning.
► Never immerse the device in water or other liquids and do not place in the dishwasher.
18.2 Cleaning
Outside of the unit: Wipe with a damp cloth or sponge and mild dish soap.
Inside of the unit: Wipe away any food or liquids with a paper towel.
If you remove the gasket during cleaning, then dry it thoroughly and reinsert it correctly,
otherwise the device cannot properly produce the vacuum.
Cleaning bags for reuse
Wash the bags in warm water with a mild dishwashing soap, then rinse them well and
allow them to dry completely before reusing
ATTENTION
► Bags used to store raw meats, fish or greasy foods should never be reused due to risk
of contamination.
19 Troubleshooting
The following table may help you narrow down and address minor malfunctions:
19.1 Safety notices
ATTENTION
► Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
19.2 Troubleshooting table
Fault
Device does not turn
on
Possible Cause
Power plug is not plugged in.
Defective power cord
Defect socket outlet
.
Plug in the power plug.
Contact Customer Service
Select other outlet
To Rectify
43
Werbung
