Elite Super Crono Bedienungsanleitung Seite 20

GB
Thank you for choosing the Super Crono
Wireless.
The Super Crono Wireless is a completely wire-
less home trainer. All the information is transmit-
ted via radio by the transmission unit to the
computer on a frequency of 433MHz. In order to
avoid possible interference, data transmission is
coded so that only the correct information, rele-
vant to training, is displayed on the computer
(even in the presence of interference on the same
frequency). The coding also enables the simulta-
neous training of several cyclists training with the
Super Crono Wireless.
IMPORTANT
• Do not stop the rotation of the bicycle
wheel by using caliper or disk brake. This
seriously damages the roller and the tire.
• If the training data is not correctly displa-
yed during the first use, the resistance unit
must be synchronised with the computer
(see the section "Synchronisation").
INTRODUCTION
Check the presence of all the following compo-
nents.
1 Wireless Fluid unit with two AA batteries (Ref. A)
1 stand (Ref.B)
1 left bushing pin (Ref.C)
1 ring (Ref.D)
1 right bushing pin (Ref.E)
1 fixing lever (Ref.F)
1 unit support upper base (Ref.G)
1 unit support lower base (Ref.H)
1 screw M6 x45 mm (Ref.I)
20
All manuals and user guides at all-guides.com
1 washer Ø6 mm (Ref.L)
1 nut M6 (Ref.M)
1 bag of unit accessories:
1 Quick release (Ref.P)
1 Travel Block (Ref.Q)
1 receiver (Ref.R)
1 console with two AA batteries (Ref.S)
1 hex wrench
2 screws M6 x 55 mm (Ref.N)
2 washers Ø6 mm (Ref.O)