Elite Super Crono Bedienungsanleitung Seite 32

GB
• Since the feet are made from soft non-slip
material, during use they may leave rubber marks
on the floor.
• During use of the Super Crono Wireless with
Elastogel roller, slight wear of the roller is to be
considered normal. Tests carried out at Elite show
that after continuous use for 20,000 km, roller
wear is around 0.1 mm, and as the total thickness
is 17.5 mm, far greater wear does not prevent
correct operation of the trainer.
• Claims due to improper or careless use will not
be acknowledged. Possible slight wear of the
rubber part comes within the norm.
• Use with narrow tyres or with non-optimum tyre
pressures can permanently damage the Elastogel
roller.
• If slipping of the wheel on the Elastogel roller is
noticed, apply a more gradual force on the pedal.
Training with the tyre slipping can permanently
damage the Elastogel roller.
ADVICE ON USE:
• For less tyre wear and better grip on the roller,
it is advisable to use tyres of 23 mm width.
• Recommended rear wheel pressure: 7 -8
atmospheres for racing tyres; 3.5 - 4 atmospheres
for MTB tyres. For particular cases, comply with
the pressure recommended by the tyre manufac-
turer.
• For quieter use, better grip of the tyre on the
roller and reduced vibration, use slick tyres (also
for Mountain bikes).
• Before use, clean the tyre with alcohol or
water.
• If the pin of the quick release supplied protrudes
more than 3 mm from the fixing nut, cut off the
protruding part (fig. 40).
PROBLEM SOLVING
1 When starting to pedal, speed and power
values remain at zero.
The synchronization between the transmitter and
32
All manuals and user guides at all-guides.com
receiver may have been lost. Proceed with re-
synchronization. (refer to the relevant section).
2 Speed is much lower than the correct value
and other values are wrong also.
Most likely the computer has been set for a resi-
stance unit different to the Supercrono Wireless
one. Control that in the SET UP phase (see "Set
Up" paragraph) TYPE number is "3".
3 While you're pedaling, the values of speed,
power, time and distance do not change as they
should (in the current values screen, speed and
power are zero, while other values do not chan-
ge).
If the information concerning speed is not registe-
ring on the head unit. Check the condition of the
batteries in the transmitter and the computer.
If the batteries are charged, try a synchronization
(see "synchronization" paragraph).
4 Sometimes speed suddenly drops down for a
brief moment.
This is caused by strong electromagnetic interfe-
rences that disturb the signal of the receiver.
5 Slope value is always positive
Slope value is given by the difference between the
resistance on the roller and the one on the road
(at the same speed). The difference between the
resistances is given to a "virtual" slope that
depends also on the speed and for this reason the
value of slope changes following the value of the
speed.
6 The computer won't turn on.
The batteries sold nowadays have variable dimen-
sions. There may not be a good connection
between the battery and contact. Try to adjust the
contact so that it sticks out a little more.
7 Every digit on the screen continuously switches
on and off.
Try to reset the computer. Push both buttons for
10 seconds until the following indications appear
on the screen: "Clear" and "Done"
8 Grade value is too high.
Control the weight set (See Settings paragraph).
The equivalent grade value is inversely proportional
40
to cyclist's weight, and if the weight set is too low,
that value results wrong.