Parkside PKGA 20-Li C2 Originalbetriebsanleitung Seite 38

GB MT
Charge­the­battery­(9) when only
the­red­LED­on­the­level­indicator­is­
illuminated.
Recharging the battery
Allow a hot battery to cool before
charging.
­ Only­charge­the­battery­(9)­when­
the­red­LED­on­the­charge­status­
indicator­(9a)­is­on.
1.­ Remove­the­battery­(9)­from­the­appli-
ance,­as­necessary­(see­„Removing/
inserting­the­battery").
2.­ Insert­the­battery­(9)­in­the­charging­
compartment­of­the­battery­charger­
(14).­
3.­ Plug­the­battery­charger­(14)­into­a­
mains outlet.
4. When the battery is fully recharged un-
plug­the­battery­charger­(14)­from­the­
mains.
5.­ Remove­the­battery­(9)­from­the­charg-
er­(14).
Overview of the control display on
the charger (14):
Green LED lights up without battery in-
serted: Charger­ready.
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.
Motor unit with drill
attachment PKGA1
Changing­the­tool
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
38
is switched on accidentally,
there is a danger of injury.
1.­ Rotate­the­keyless­chuck­(1)­towards­
­until­the­drill­chuck­aperture­is­
RELEASE
large enough to accommodate the tool.
2.­ Insert­the­tool­as­far­as­possible­into­
the­keyless­chuck­(1).­
3.­ Turn­the­keyless­chuck­towards­
order­to­clamp­the­tool.
4. To remove the tool again, rotate the
keyless­chuck­(1)­towards­
the­drill­chuck­aperture­is­large­enough­
to remove the tool.
Choice­of­gear
­Stop­appliance­before­
changing gear.
1.­ Wait­for­the­appliance­to­come­to­a­
standstill.
2­­ Slide­the­gear­selector­(3)­into­the­re-
quired­position:
1: 0-400 min
-1
2: 0-1350 min
Set the direction of rotation
The­appliance's­direction­of­rotation­can­be­
changed with the rotational direction switch.
The arrow on the direction switch indicates
the­working­direction.
1.­ Wait­for­the­appliance­to­come­to­a­
standstill.
2.­ Push­the­rotational­direction­speed­
(7)­into­the­desired­position:
To drill and screw in screws: Press the
direction­switch­with­the­arrow­poin-
ting forwards
To unscrew screws: Press the direction
switch­with­the­arrow­pointing­back-
wards
GRIP
RELEASE
-1
in
until