Parkside PKGA 20-Li C2 Originalbetriebsanleitung Seite 35

tact with hidden wiring. Contact­
with a live wire can also cause a
charge­in­metal­parts­of­the­device­and­
result­in­an­electric­shock.
• Fasten and secure the workpie­
ce by means of clamps or with
another method on a stable un­
derground.­If­you­hold­the­workpiece­
only with your hand or against your
own body, it will stay instable and this
can lead to a loss of control.
• Keep hands away from the
sawing area. Do not reach
underneath the workpiece. Al­
ways stand to the side of the
saw when working. Upon­contact­
with­the­blade­there­is­a­risk­of­injury.
• Only when the electric tool is
turned on should the sawing
blade be moved against the
workpiece.­There­is­a­risk­of­kickback­
if­the­tool­insert­jams­in­the­workpiece.
• Make sure that the footplate
is securely placed against the
workpiece during sawing. The
sawblade can tilt and lead to loss of
control­over­the­power­tool.
After you have finished work, turn
•
the power tool off and do not
pull the sawblade out of the cut
until it has come to a standstill.
In­this­way­you­will­avoid­any­kickback­
and­can­safely­put­down­the­power­tool.
• Use only undamaged saw­
blades in perfect condition. Bent
or­blunt­blades­can­break,­adversely­
affect­the­cut­or­cause­kickback.
• Do not brake the sawblade af­
ter switching the appliance off
by applying side pressure. The
sawblade­may­be­damaged,­break­or­
cause­a­kickback.
Tighten the material firmly. Do
•
not support the workpiece by
hand or foot. Do not touch any
objects or the ground with the saw run-
ning.­There­is­a­risk­of­kickback.
• Hold the power tool tightly with
both hands while working and
ensure a secure footing. The
power­tool­is­guided­more­securely­
with both hands.
• Wait until the power tool has
stopped before placing it down.
The tool insert can tilt and lead to loss
of­control­over­the­power­tool.
• Switch the appliance off im­
mediately if the sawing blade
jams.­Spread­the­saw­cut­out­and­pull­
the blade out carefully. This can lead
to­loss­of­control­over­the­power­tool.
3) SPECIAL SAFETY INFORMATION
DURING SANDING AND
SCRAPING
• Only use the power tool for dry
sanding. Do not scrape moist
materials. Penetration of water into
the­power­tool­increases­the­risk­of­
electric­shock.
• Avoid overheating the sanded
object and the sander itself. Pos-
sible­fire­hazard.
• The workpiece gets hot dur­
ing grinding. Do not touch the
machined area, allow it to cool
down.­There­is­a­risk­of­burning.­Do­
not­use­coolants­or­the­like.­
• Always empty the dust con­
tainer before work breaks.
Sanding­dust­in­the­dust­sack,­micro­
filter,­paper­sack­(or­in­the­filter­sack­or­
extraction­system­filter)­can­self-ignite­
under unfavourable conditions such
as­flying­sparks­caused­by­grinding­
metals. Particular hazards are caused
if­the­sanding­dust­is­mixed­with­paint,­
GB MT
35