Herunterladen Diese Seite drucken

Pioneer CLD-700 Bedienungsanleitung Seite 70

Werbung

TROUBLESHOOTING
Incorrect operations are often for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical
appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
PIONEER authorized service center or your dealer to carry out repair work.
SYMPTOM
1. Disc table is not ejected when
OPEN/CLOSE is pressed.
2. Disc table
comes
out.
3. Remote
control
does
not work.
4. Operation of the remote control
unit causes the TV to operate
improperly.
WHEN
A LASERVISION
DISC IS BEING PLAYED
SYMPTOM
5. Disc is rotating but there is no
picture.
6. Picture
continuously
vertically.
7. Particular disc does not playback
properly. The playback stops in
the middle of the disc program.
70
En
Power cord is not properly plugged into AC wall
socket.
Power
switch
is not turned
Disc is dirty.
The disc is not properly set on the disc table.
Moisture has condensed on parts in the player.
Disc is warped.
NTSCsystem discs which is used in U.S.or Japan
is loaded.
Batteries
are weak.
There is an obstacle between the player and the
remote
control
unit.
Remote control unit is not in a good location for
transmission.
Some TV sets have remote
operate improperly in response to the remote
control unit of the player.
The TV set is not turned
Wrong connections from player to TV.
moves
The TV vertical hold control is not adjusted
properly.
The playing surface Ofthe disc is dirty.
The disc is warped.
CAUSE
on.
control functions
that
CAUSE
on.
REMEDY
Plug in power cord.
Tum on power switch.
Clean
disc.
Set the disc properly.
Remove disc and let player stand for 1
to 2 hours until it is dry.
Try to alleviate the warp.
(Refer to
Symptom 7, remedy column.)
NTSC system discs cannot be used
with this player.
Replace batteries.
Remove
the
obstacle
or
shift
remote control position.
Operate the remote control unit in front
of the player.
Move the IV and the player further
apart, or cover the remote sensor of
the TV during disc playback.
REMEDY
Turn on TV.
Make
correct
connections.
Adjust vertical-hold control on TV.
Use a soft cloth and lightly wipe off
the dirt from the surface
of the disc. If
necessary,
moisten
a cloth with diluted
neutral detergent to remove heavy dirt
or fingerprints.
LD discs only
Put the
disc
into
the
protective
envelope, then place it on a flat desk
top. Subsequently, place a flat board
e.g. glass plate on the disc, and load it
with about 4 —5 kgs (about 10 lbs). If
it is left in this state for one day,
sometimes the warp will be alleviated.
Heavy books
about 4
5 kgs
(10 lbs)
Glass plate
Protective
Glass plate
envelope
the

Werbung

loading