Sharp VL-C780S Serviceanleitung Seite 192

VL-C780S/H/X
VL-C7400E
VL-C6S0S/H/X
VL-C6&400E
5-5. Other keys input and output action
1. Full auto key
When the FULL AUTO es (SW001) is switched to "FULL AUTO", the camera microcomputer input (63)
: GREEN KEY terminal becomes "H" input, setting the camera microcomputer output (10) A/F, (13) W/B LOCK
and (45) DATA in the fixed mode.
Focus, White balance, @ output (3 output @3) output
swoo1 Electronic shutter, Key input (white balance) (shutter)
Unallowed H (auto) L(auto) | Standard data
Allowed Changes according to the input
Table 5-5 {a).
- swoo. = ta
) FULL AUTO
TO WB IC
TO CCD TIMING IC
Figure 5-5 (a).
2. Pause remote
The input signal of tine REMOTE JACK (J8803) of the VCR operation section is INGUITRE in the camera
microcomputer input (30) PAUSE REMOTE.
The camera microcomputer transfers the input signal of the pause remote control connected to the
J terminal to the VCR microcomputer.
Condition of remote jack
Open
(auc remote control switch OFF)
Pause remote control switch ON =
Table 5-5 (b).
31