Sharp VL-C780S Serviceanleitung Seite 173

Increase or decrease the flashing numerics (hexadecimal digit) with the
FF and REW keys to select an address to be adjusted. (Address in initial
condition is 30H.)
When PB key is pressed, data is read out of the specified address. (Read ADJ
out the data by READ command from the camera microcomputer.) 2C A3
Increase or decrease the data by the FF and REW keys for adjustment. The
data display section flashes. (The data is outputted to the camera
microcomputer by DAOUT command.)
f the FF or REW key is pressed continously longer than 0.3 sec., a repeat mode is set. The cycle of repeat is 100
nsec, and in data setting, the data is changed by + 4 when the key is pressed two more seconds. :
» Auxiliary key input
The microcomputer enables direct key entry in VCR mode system provided for the camera microcomputer, not
through data transfer from the camera microcomputer, so that it can perform basic operation check without
deing connected to the camera microcomputer.
Auxiliary key entries are assigned to the empty levels in the key 2 and 3 entries.
The keys with are for auxiliary entries in the table below.
12