Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Removing sanding sheet:
1. Remove the sanding sheet (14) from the
sanding disc (1).
Trial run:
Perform a trial run at top speed without a
load for at least 1 minute whenever you
change the sanding paper. Remain outside
the hazard area while doing so.
Setting the sanding table
angle
The angle of the sanding table (8) can be ad-
justed continuously between -10° and +50°.
1. Loosen the screws (6).
2. Set to the desired angle.
3. Tighten the screws (6).
Using an angle stop
1. Loosen the angle stop screw (10b).
2. Slide the rail of the angle stop (10a) into
the desired position in the groove (9) on
the sanding table (8).
3. Set the desired angle using the scale
onto the rail marking (10a).
4. Fix the angle stop (10) in place by
tightening the screw (10b).
Connecting external dust
extraction
Please check the operating manual
of your vacuum cleaner to ascertain
whether it is suitable for the suction
of grinding chips.
Connecting external dust
extraction:
1. Place the angle adapter (11) into the
opening on the device.
24
Ensure that you slide the lug on the
angle adapter (11) into one of the two
slots in the device opening (see de-
tailed illustrations).
2. Rotate the angle adapter (11) into a ver-
tical or horizontal position to secure the
angle adapter (11) against falling out.
Removing external dust
extraction:
3. Gently turn and pull on the angle
adapter (11) to remove it.
It can be removed when the arrow on
the angle adapter (11) and the mark-
ing on the device housing are exactly
aligned.
An additional adapter (12) with a
larger diameter is provided with the
device and this can, if required, be
attached to the angle adapter (11).
If necessary, you can connect the
suction hose of a vacuum cleaner
directly onto the angle adapter.
Operation
Before initial operation, perform a trial run
at top speed without a load for at least 1
minute. Remain outside the hazard area
while doing so.
Switching on and off
Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. Select the desired speed using the
speed regulator (2).
Werbung
