Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• If the power tool's mains
connection cable is damaged, it
must be replaced with a specially
prepared mains connection
cable, which is available from
the online shop
(www.grizzlytools.shop).
Residual risks
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear protec-
tion is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding discs.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic fi eld which, under certain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.
Initial start-up
Avoid unintentional starting.
Ensure that the mains plug is removed
before carrying out any adjustments,
maintenance or repair work.
Before operating the disc sanding device,
you must secure it against tipping.
Securing the disc
sanding device
Secure the disc sanding device horizon-
tally (
) or vertically (
surface.
The enclosed screw clamp (13) must grip
into one of the two receptors (5).
Mounting/dismounting the
sanding table
Dismounting the sanding table:
1. Loosen the screw (6) on both sides.
2. Pull the sanding table (8) off the device.
Mounting the sanding table:
1. Push the sanding table (8) back onto
the device.
2. Fasten the sanding table again on both
sides with the screw (6).
Replacing sanding paper
Caution! Risk of injury! Discon-
nect the device from the power sup-
ply to prevent unintentional starting.
For easier replacement, dismantle
the sanding table (8) beforehand.
Attaching sanding sheet:
1. Press the sanding sheet (14) evenly
onto the sanding disc (1).
GB
) to the working
23
Werbung
