Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
5) Service
a) Have your power tool serviced
by a qualifi ed repair person
using only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety instructions for
disc sander
Caution! Risk of injury!
Wear personal
protective equipment.
Wear safety goggles, hearing
protection, a dust mask and gloves.
• When working under dust-prone condi-
tions, ensure ventilation holes are clear.
Disconnect the device from the power
supply prior to cleaning.
• Caution, risk of injury! The sanding
disc will continue to run for a short time
after switching off the machine.
• Never make the warning labels on the
power tool illegible.
• Attach the power tool to a solid,
fl at and horizontal surface. If
the power tool is prone to slipping or
wobbling, the bit cannot be guided
smoothly and safely.
• The bit should only be moved
against the workpiece when the
device is turned on. Otherwise there
is a danger of the bit becoming jammed
in the workpiece and the workpiece rotat-
ing with the bit. This can lead to injuries.
• Switch the power tool off imme-
diately if the bit jams.
The bit jams when:
- The power tool is overloaded;
- It becomes stuck in the workpiece be-
ing machined.
22
• Set the correct speed before
starting work.
• After completing your work, do
not touch the sanding disc until
it has cooled down. The bit be-
comes very hot during use.
• Inspect the cable regularly and
have a damaged cable repaired
only by an authorised customer
service centre. Replace damaged
extension cables. This will ensure
that the power tool remains safe.
• Store the power tool safely
when not in use. The storage
place must be dry and lockable.
This prevents the power tool from being
damaged as a result of being stored or
operated by inexperienced people.
• Never leave the tool before it
has come to a complete stand-
still. Bits still in motion can cause injury.
• Do not use the power tool with
a damaged cable. Do not touch
the damaged cable and pull the
mains plug if the cable is dam-
aged while working. Damaged ca-
bles increase the risk of electric shock.
• Avoid abnormal body postures.
Ensure secure footing and keep your
balance at all times.
• To avoid hazards, any replacement of
the plug or the connection line must al-
ways be executed by the manufacturer of
the electric tool or their customer service.
• Water must be kept away from the
power tool's electrical parts and people
within the working range.
• Caution! Never remove any
loose splinters, chips or jammed
pieces of wood when the sand-
ing disc is still running. Always
switch off the machine before repairing
any faults or removing jammed pieces
of wood - pull the mains plug.
Werbung
