Werbung
ENGLISH
Troubleshooting
els the personal computer powered on?
eHas the power supply cable of personal computer been connected
correctly?
els the label of media peeled off?
cr Insert the supplied pin into manual eject hole to open the tray.
Tray fails to close.
eHas the media been inserted correctly?
e Has the drive's SCSI ID been set correctly?
eHas the drive's terminator been set correctly?
è Are the drive and computer connected correctly?
eHas a floppy disk been left inside the computer?
els the total length of SCSI cable shorter than the length specified by the
interface board (card) to be used?
@ Has the drive's terminator been set correctly?
e Are the drive and computer connected correctly?
els the device driver installed correctly?
Tray fails to open.
Personal computer
fails to work.
Drive cannot be
accessed normally.
els the SCSI host adaptor recognized correctly?
els the device driver installed correctly?
cr In case drive letter of CD-ROM/DVD-ROM side is recognized only,
device driver is not installed.
eDid you initialize (format) the DVD-RAM disc?
eDid you access the correct drive letter assigned to the drive?
eDid you insert the single side DVD-RAM disc with the space for an
adhesive label facing up?
eis the DVD-RAM disc dirty?
Has condensation formed in the drive?
(Wait an hour or so after turning on the computer for the drive to dry out
and then try operating.)
Drive is not
recognized on
Windows 95.
DVD-RAM disc
cannot be read or
written to.
e Did you initialize (format) the PD cartridge?
eDid you access the correct drive letter assigned to the drive?
eDid you insert the PD cartridge with the space for an adhesive label
PD cartridge cannot
facing up?
be read or written to. | els the PD cartridge dirty?
eHas condensation formed in the drive?
(Wait an hour or so after turning on the computer for the drive to dry out
and then try operating.)
eDid you access the correct drive letter assigned to the drive?
Only the discs supported by this drive can be used.
eHave the discs been placed correctly in the tray?
eDid you insert the discs with label facing up?
eAre you using correct software program for playing discs?
els the disc dirty, scratched, cracked, warped, written on the surface or is a
label put on the disc?
eHas condensation formed in the drive?
(Wait an hour or so after turning on the computer for the drive to dry out
and then try operating.)
Discs cannot be
read.
Werbung
