Werbung
ENGLISH
ai
Rear panel of this DVD-RAM drive
Rückwand dieses DVD-RAM-Laufwerks
Panneau arriere du lecteur DVD-RAM
BR
E ER
TER
FERN
TR
TR
TER
TEE
v—..n.
nm...„.„unn....e......
meer.»
SHEP
RHETT
ERE
ETT EE
HET EH BROS
"5"
"on" EF
"OFF" IT
"g"
CELLIER
RIRE
LL
IE
FETT
RE
EEE
TH
TER»
Jumper pin setting E
a When you insert a jumper pin, "ON" is set.
S
SCSI ID setting (Factory Default: 4)
@ Factory use only (No jumper pin)
SCSI IDs are a number identifying each SCSI
|
unit. Consequently,
SCSI IDs must be set so
9
|
that no two units duplicate each other on the
©
SCSI ID setting
SCSI bus.
©
|
|
Note:
@ TERMINATOR setting
eHard Disk Drive: 0
@ Factory use only (No jumper pin)
eCD-ROM Drive: 3
e SCSI Host Adaptor: 7
Check the SCS} ID (refer to devices instruction
manual) for each device connected on the SCSI
bus.
Set the DVD-RAM
drive's
ID so as
not to
duplicate any other device's ID.
E Terminator setting
(Factory Default: ON)
A terminator refers to a terminating resistance.
The
terminators
must
be set properly
when
SCSI units (including the DVD-RAM drive) have
been connected to the personal computer.
eWhen the DVD-RAM drive is a terminating
device (for example, illustration @, @ on
page 20)
Set to ON.
e When the DVD-RAM drive is not a terminating
device (for example, illustration @-@ on
page 20)
Set to OFF.
Werbung
