Werbung
Installing SoftPEG™ (MPEG1 software decoder)
After installing MPEG 1 Coder, it is required to install SoftPEG™.
Install SoftPEG™ separately by following the procedure below.
1
Note:
Insert the supplied CD-ROM
into the DVD-RAM
drive, then from the
Start menu select [Run].
In the "Open" box,
enter
"e:\softpeg\setup.exe",
then
Type the name of a program, folder, or document, and
Windows will open it for you.
click [OK].
=
Open:
le:\softpeg\setup.exe
Ki
Installation begins.
SS
SRE
eThis assumes
that the DVD-RAM
drive is
"Or YT Cancel
I Browse... |
assigned drive letter E:.
Follow the on-screen instructions to proceed.
eSoftPEG™ is registered as standard MCI device.
The MPEG decoder registered before SoftPEG™ installation will be replaced by SoftPEGTM.
Uninstalling the supplied application software
To delete supplied application software that you have installed on your personal computer,
uninstall it by
following the procedure below.
1
2
From the Start menu, select [Settings], then [Control Panel].
eYou may also open the [My Computer] window and then select [Control Panel].
IP
emove Programs Properties
RIES
Double-click [Add/Remove Programs]
and select the application you wish to
delete.
Instal/Uninstal | Windows Setup | Startup
Disk |
To install a new program from a floppy disk or CD-ROM
drive, click Install
Click [Add/Remove] button.
——
——
i
V we)
` The folowing software can be automaticaly removed by
1
US
Windows. To semove a program ot to modify its installed
components, select it from the Sst and cek
Add/Remove.
eFollow the on-screen instructions to proceed.
eWhen you finish uninstalling, reboot your system.
a
ce
Werbung
