Stihl RMI 422.1 Gebrauchsanleitung Seite 145

Recommendation:
Always switch on GPS protection.
Before switching on, enter the
mobile phone number of the owner
in the app ( 10.) and set the
safety level "Low", "Medium" or
"High" on the robotic mower.
4. Change PIN code:
The 4-digit PIN code can be
changed if required.
The "Change PIN code" menu item
is only displayed in the safety levels
"Low", "Medium" or "High".
● First enter the old PIN code and confirm
with OK.
● Then enter the new 4-digit PIN code
and confirm with OK.
STIHL recommends writing down
the new PIN code.
If the PIN code is entered
incorrectly 5 times, a 4-digit master
code is required, otherwise
automatic operation is switched off.
For the creation of a master code,
you must provide your STIHL
specialist dealer with the 9-digit
serial number and the 4-digit date,
which are displayed in the selection
window.
5. Start signal:
For switching on and off the acoustic
signal that sounds when the mowing
blade is activated.
6. Menu signal:
For switching on and off the acoustic
click that sounds when a menu is
opened and a selection is confirmed with
OK.
0478 131 9957 A - EN
7. Keylock:
When the keylock is switched on,
the buttons on the display can
only be operated if the Back
button is pressed and held and the
control pad is then pressed forwards.
The keylock is activated 2 minutes after
the last button has been pressed.
8. Link iMOW® and dock:
Following initial operation, the
robotic mower can only be operated
in conjunction with the docking station
installed.
Following a replacement of the docking
station or of electronic components in the
robotic mower or for operation of the
robotic mower on an additional mowing
area using a different docking station, the
robotic mower and docking station must be
linked.
● Install the docking station and connect
the perimeter wire. ( 9.8), (
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
● After pressing the OK button,
enter the PIN code. The robotic
mower will then search for the
wire signal and save it automatically.
This process takes several minutes.
( 9.11)
No PIN code is required in the
safety level "None".
11.16 Service
1. Blade change:
Installation of a new mowing blade is
confirmed with OK. The counter is reset.
2. Find wire break:
If the red LED on the docking station
flashes rapidly, there is a break in the
perimeter wire. (
● Finding a wire break (
3. Hibernation:
9.10)
OK places the robotic mower in
hibernation. The settings are kept, the time
and date are reset.
● Charge the battery fully before
hibernation.
● When resuming operation, wake up the
machine by pressing any button.
4. Reset settings:
The robotic mower is reset to the factory
defaults with OK, the installation assistant
is restarted. (
● Enter the PIN code after pressing
the OK button.
No PIN code is required in the
safety level "None".
13.1)
16.7)
9.6)
143