Care, Maintenance And Disposal; General Remarks; Every Start-Up; Every 2 Months - Fronius TransPocket 1500 Bedienungsanleitung

Care, maintenance and disposal

Under normal operating conditions the power source requires only a minimum of care and

General remarks

maintenance. However, it is indispensable to follow some important points to ensure the
operationality of the welding machine for many years.

Every start-up

-
-
-

Every 2 months

Every 6 months

-
-

Disposal

Carry out disposal in accordance with the valid national and local regulations.
Warning! An electric shock can be fatal. Before opening the machine:
- Shift the mains switch into the „O" position
- Unplug the machine from the mains
- Put op an easy-to-understand warning sign to stop anybody inadvertently
switching it back on again
- Using a suitable measuring instrument, check to make sure that electrically
charged components (e.g. capacitors) have been discharged.
Check mains cable, mains plug, welding torch, interconnection cable assembly and
bondings for damage
Check whether the allround distance of 0.5 m (1ft. 8in.) is kept to ensure that the
cooling air can easily flow and escape.
Note! Furthermore, air inlets and outlets must in no case be covered, not even
covered partly.
Optional: clean air filter
Dismantle machine side panels and clean machine inside with dry reduced compres-
sed air.
Note! Risk of damage to electronical components. Clean electronical compo-
nenets from a certain distance only.
If a lot of dust has accumulated, clean the cooling-air ducts.
2 0