Table Of Factory Settings For Parameters; Generator-Powered Operation; Requirements - Fronius TransPocket 1500 Bedienungsanleitung

"Frequency" Important! The frequency parameter is only available on the TP 1500 TIG.
parameter (for
the TIG pulsed- The frequency parameter is for setting the frequency of the pulsed arc.
arc welding
process) The welding properties achieved in TIG pulsed arc welding are determined to a large
extent by the frequency of the pulsed arc.
- Stage 0 ................ Low frequency
- Stage 4 ................ High frequency
Table of factory Important! The table below shows the factory settings for the parameters described
settings for above.
parameters
TP 1500 TIG
TP 1500 / 1500 RC

Generator-powered operation

Requirements

The TP 1500 / TP 1500 RC and TP 1500 TIG power sources are completely suitable for
being run on generator power, provided that the apparent power delivered by the gene-
rator is at least 10 kVA.
Fig.14 Tolerance range of the mains voltage
TP 1500 TIG
60 Hz
4 Hz
2 Hz
1 Hz (factory setting)
0.5 Hz
„Arc-force"
40 A
40 A
Note! The voltage delivered by the generator must NEVER overshoot or
undershoot the range shown.
195 V~
-15%
1 9
„Characteristic" „TIG comfort-stop"
4 A/V Deactivated
4 A/V -
230 V~
+15%
„Frequency"
1 Hz
-
265 V~