Profitec Pro 700 Bedienungsanleitung Seite 33

Bedienungsanleitung / User manual Pro700
Weak "body"
Foam instead of crema
The machine is switched on, but
the machine does not work.
The machine does not stop
working and takes in air.
Filter holder/ brew group is
dripping.
If the machine will not be used for a long period of time, it is recommended to
.. clean the brew group (see instructions on page 27). Afterwards, please do not clamp the filter holder back
into the group.
..to empty the boilers. Turn the switch of the operational machine to position off. Open the hot water valve
and the boiler water is now discharged by the remaining pressure through the hot water release. Close the
hot water valve after the water has been released. The coffee boiler is emptied out via the brew group.
Activate the brew group lever and release the water into the drip tray. Please make sure some water remains
in the coffee boiler. Start-up of the machine is the same as initial startup (item 5.1).
How to froth milk like a "Barista"
If possible, use cold, fresh milk with a fat content of approx. 1.5 % or 3 %. Even homogenized milk is
•
suitable - if you prefer.
Use a frothing container (made of metal) with a minimum volume of 0.5 litres. The diameter of the
•
container should not be too wide. A narrow and high container is perfect.
Open the steam valve for approx. 5 seconds to release the condensation water and to create dry steam.
•
Fill 1/3 of the frothing container with milk and place it under the steam nozzle. The nozzle should be
•
immersed in the middle of the frothing container, just below the surface.
Slowly open the steam handle or the steam lever valve. Steam pervades the milk.
•
Keep the frothing container still.
•
There is too much ground coffee.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The beans are improper.
The setting of the coffee grinder
is not suited for the coffee beans
in use.
PID-display is turned off: There is
not enough water in the fresh
water tank
Water has been refilled, PID-
display is off
The water tank is not fixed
properly.
Machine in use with direct water
connection, but switch in
position "0" (=position water
tank). Machine does not take in
water.
Machine in use with water tank,
but switch in position "1" (=
position direct water connection).
Filter holder is not fixed properly.
Group gasket is broken.
32
Use approx. 7 g – 9 g of coffee
for every cup.
Set a finer grind..
Use fresh coffee.
Use approx. 7 g – 9 g of coffee
for each cup.
Clean the shower screen.
Use another type of coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)
Refill water.
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet point
on the lower part of the floater
side.)
Fix the water tank properly.
This switch is located behind a
cover panel at the back of the
machine
This switch is located behind a
cover panel at the back of the
machine
Fix the filter holder properly.
Change group gasket and shower
screen.