Scheppach PGS75 Originalbetriebsanleitung Seite 36

7. Fit the feed funnel (2) with the feed funnel rubber
seal (H) as described in 8.3.
ATTENTION
Remove the socket spanner with extension
from the hexagon on the shredding unit.
Note:
If one of the following points occurs after replacing the
blade, contact an authorised specialist dealer who can
check the product for damage and replace the blades if
necessary:
• Not a satisfactory cutting result.
• The product vibrates excessively.
• The product causes unusual noises.
13.2 Damaged blades (25)
WARNING
There is a risk of injury if you work with a
damaged blade.
– Wear protective gloves!
– For safety reasons you should only ever have your
blade sharpened and balanced by an authorised
specialist workshop. For optimum results it is rec-
ommended that the blade should be inspected
once a year.
– When changing the blade, only use original spare
parts.
• If it came into contact with a foreign object. Inspect
the product for damage and perform the required re-
pairs before starting again and working with the
product. If the product begins to experience excep-
tionally strong vibrations, switch it off immediately
and check it.
• Use only blades and accessories recommended by
the manufacturer. Use of other insert tools and ac-
cessories may result in injury to the user.
13.2.1 Sharpening the blades (25)
Note:
In order to avoid an imbalance, sharpening should only
be performed by an authorised specialist workshop.
13.3 Checking the oil level
1. Check the oil level as described in 9.1.
36 | GB
13.4 Changing oil (Fig. 8, 13)
WARNING
Health hazard!
Inhalation of fuel / lubricating oil vapours and exhaust
gases can cause serious damage to health, uncon-
sciousness and in extreme cases death.
– Do not breathe fuel / lubricating oil vapours and
exhaust gases.
– Operate the product outdoors only.
ATTENTION
Product damage!
If the product is operated without or with too little en-
gine oil, this can lead to product damage.
– Fill with fuel and oil before starting the machine.
The product is delivered without engine oil.
ATTENTION
Environmental damage!
Spilled oil can pollute the environment permanently.
The liquid is highly toxic and can quickly lead to water
pollution.
– Fill/empty oil only on level, paved surfaces.
– Use a filling nozzle or funnel.
– Collect drained oil in a suitable container.
– Wipe up spilled oil carefully immediately and dis-
pose of the cloth according to local regulations.
– Dispose of oil as per local regulations.
Change engine oil after 50 hours of operating time.
The engine oil change should be carried out while the
engine is at operating temperature.
1. Unscrew the oil filler cap with oil dipstick (16).
2. Provide a collection container (not included in the
scope of delivery).
3. Unscrew the cover cap from the oil drain hose (9).
Hold the oil drain hose (9) over the collection bucket
and allow the oil to run out.
4. Close the oil drain hose (9) again once the oil has
drained completely.
5. Fill up with new SAE 10W-40 engine oil (approx.
0.55 l).
6. Wipe the oil filler cap with oil dipstick (16) with a
clean, lint-free cloth.
7. Screw the oil filler cap with oil dipstick (16) back into
the filling nozzle until it reaches the stop.
8. Unscrew the oil filler cap with oil dipstick (16) and
read the oil level in the horizontal position. The oil
level must be in the middle on the oil filler cap with
oil dipstick (16).
www.scheppach.com