Rational iCombi Gas Umbauanleitung Seite 20

1 | MI_2156 Gas valve (hot air and steam) - dismantling and installation
The marked adjusting screws (1) and (2) may only be tightened with a
torque of 1.2Nm (+/- 0.1Nm).
Too high a torque will damage the valve.
3. Conduct a gas leak check after installation.
4. After the installation, carry out a leak test and flue gas analysis.
Note: Do not use leak detection spray when checking gas components for
leaks. The leak detection spray may damage adjacent components.
>>
The installation is complete.
20 / 156
NOTICE
1
2