Rational iCombi Gas Umbauanleitung Seite 16

1 | MI_2156 Gas valve (hot air and steam) - dismantling and installation
Safety instructions
High voltages when connecting to the mains power
Danger to life due to high voltage.
Disconnect from the power supply.
n
Make sure the unit is disconnected from the power.
n
Sharp edges on the housing
Risk of cuts on the housing when working in the unit.
Wear protective gloves.
Do not use leak detection spray when checking gas components for leaks.
The leak detection spray may damage adjacent components.
Revision Log
Changes from previous version of this manual:
Components included in the scope of delivery – change of article number:
n
Compensation line cpl. 061-202G – (Art. 70.01.268P)
In the chapter "Work steps – Installation of the gas hose on floor units",
n
the note "Do not use leak detection spray when checking gas components
for leaks. The leak detection spray may damage adjacent components." has
been added.
Work steps - Removal of the gas valve hot air and steam
a
The unit is switched off and voltage-free.
a
The electrical compartment is open.
a
The gas supply is switched off.
1. Remove all cables from the gas valve (1) and the gas blower (9).
16 / 156
DANGER
CAUTION
NOTICE