OHAUS Frontier FC5513L Bedienungsanleitung Seite 22

TM
Frontier Centrifuge FC5513, FC5513R, FC5513L
4. SETTING
4.1 Basic adjustments
4.1.1 Change the type of rotor
Before the first operation and after each rotor change, you have to set the rotor type. You find each rotor type in the
printed order number on the rotor.
Example:
Angle rotor order number: 30130871
Rotor Type on the display = 71
Turn on the centrifuge and open the lid. Now simultaneously press the keys "Quick Spin"(8) and "Stop/Lid"(9). In
the display "RPM/RCF" the old rotor type no "71" appears. With the potentiometer you can now set the rotor type.
To store the new setting please press the "Start" (10) key. Inside the display, "Store" appears as confirmation.
Now all-important rotor parameters for the centrifuge are stored.
ATTENTION:
The set rotor type must always be the same as the actual rotor type used; otherwise, the equipment
might be damaged.
The rotor type can be checked during the run by pressing the key "Quick Spin"(8).
4.1.2 Access to mode "Operating Data"
When using the centrifuge, the following parameters can be set:
- Temperature Indication in °C or °F (only FC5513R)
- Acoustic signal turn on/off
- Keyboard sound turn on/off
- Sleep Mode On / Off
The following operating data can be retrieved in this menu:
While the centrifuge is turned off, press simultaneously the keys "Time"(7) and "Stop/Lid" (9) and turn on the
main switch of the centrifuge. Now release both keys and as a result a display test is executed for approx. 5
seconds. All indicators will appear at the same time (see figure 27).
A-1
- Number of Starts
- Operating Hours of Centrifuge
- Operating Hours of Motor
- Software Version
- Error List
- Function of the Imbalance Sensor
- Operation of Keyboard
- Hardware Version
- Intermediate Circuit Voltage in Volt
Figure. 26
EN-17
2
10
9
8