OHAUS Frontier FC5513L Bedienungsanleitung Seite 15

EN-10
3.2 Lid control
3.2.1 Lid open
Before the run, when the lid of the centrifuge is closed, the word "close" (M1) appears in the display "RPM | RCF"
(A-1). Additionally, the code number of the preset rotor is shown in the display. Even if the rotor is not inserted. By
pressing the key "Stop/Lid" (9) you can release the lid of the centrifuge. As soon as the lid is completely released,
the word "open" (M2) appears. Now you can open the lid of the centrifuge.
Please refer to figure 12 below for reference.
During the run you can call up the rotor type at any time by pressing the key "Stop/Lid" (9).
3.2.2 Lid lock
The lid should only be put down slightly. A lid lock closes the lid, at the same time the word "open" (M2) disappears
(refer to figure 15).
As a sign that the centrifuge is ready for starting, in the display "RPM | RCF" (A-1) the word "close" (M1) appears.
Simultaneously the word "rotor" (M3) is displayed, as well as the code number of the rotor, which is in the centrifuge
system, "no 71" (M4). With that, all rotor specific data, like e. g. max. speed, acceleration etc., are adopted.
ATTENTION:
Don't grip your fingers between lid and device or locking mechanism when closing the lid!
Before closing the lid, please check if the rotor is tightened.
3.3 Preselection
3.3.1 Preselection of speed / RCF-value
This pre-selection is activated through the key "RPM/RCF" (5) (refer to figure 13 below). By pressing the key once
the word "rpm" (M5) flashes. By pressing the key twice, the pre-selection of the centrifugal forces can be selected.
Then the flashing word "rcf" (M6) appears. You can set the desired values with the adjusting dial (1). In the display
(A-1) the regulated value is shown permanently, before, during and after the run.
M2 M4
A-1
Figure. 12
TM
Frontier Centrifuge FC5513, FC5513R, FC5513L
M3
M1
4
9