OHAUS Frontier FC5513L Bedienungsanleitung Seite 18

TM
Frontier Centrifuge FC5513, FC5513R, FC5513L
13
3.4 Radius correction
If you use adapters or reducers, it could change the centrifugal radius of the respective rotor. In that case you can
correct the radius manually. Please proceed as follows:
Close the lid, then press the key "Time" (7) (refer to figure 16) and the key "Prog/Setup" (3) at the same time and
hold them.
In the display "Time/Prog" (A-4) the word "radius" (M9) appears. By the adjusting dial (4) you can preselect the
respective radius correction (See Table 7, APPENDIX) in steps of 0.1 cm. As soon as you have set a radius correction
the word "radius" (M9) appears. This word will be visible until you put the radius correction back to 0 again.
3.5 Program
3.5.1 Storage of programs
You can store up to 99 runs with all relevant parameters, including the used rotors. You can use any free program
number and call it up again.
Put the needed rotor into the centrifuge. By pressing the key "Prog/Setup" (3) in the display "Time/Prog" (A-3) the
word "programm" (M10) appears. With the adjusting dial (4) you can chose the desired program number.
If a program number is already occupied, in the display "RPM/RCF" (A-1), the words "rotor" (M3) and "xx" (M4)
will appear. In case of free program numbers, 0 appears
6
M9
A-4
Figure. 17
A-4
Figure. 18
EN-13
9
3
1
7