Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TM
Frontier
Centrifuge FC5513, FC5513R, FC5513L
4.1.4
Keyboard sound turn on / off
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "B". with the adjusting dial (4). As a
result, in the display "RPM/RCF" (A-1), the word "ON/BEEP " appears. After pressing the key "RPM/RCF" (5), you
can turn the keyboard sound (On) or (Off) with the adjusting dial (4). (see figure 30).
After you have stored the settings (see 4.1.2) you can change back to the normal program mode again by switch
off the centrifuge for a short while.
A-1
4.1.5
Sleep Mode On / Off
After not using the centrifuge for 5 minutes, the display automatically switches off. By pressing any bottom, it
switches on again. Proceed as illustrated, under point 1.8.2, to enter this program mode, press the key,
"accel/decel" (5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter "I" with the control
field (1). As a result, appearing in the display, "rpm/rcf" (A-1), the word "SLEEP". After pressing the key, "rpm/rcf"
(4), turn the sleep mode function (On) or (Off), with the rotary field (1).
After the settings have been stored by user, the normal program mode can be changed back again by switching off
the centrifuge, for a short period.
4.1.6
Call up operating data
ATTENTION:
This should only be performed by advance user or service engineer.
In the mode "Basic Adjustments" you can call up the operating data of the centrifuge. Please proceed as
described under point 4.1.2 to enter this program mode. Press the key "Accel/Decel" (6). In the display "Acc/Dec"
(A-2) the word "Service" flashes.
With the adjusting dial (4) the different information can be accessed:
A= previous starts of the centrifuge
H= previous operating hours
S= software version
r= converter software
E= list of previous error messages
h= running time of the motor
F= Function of the Imbalance
Sensor
P= Operation of Keyboard
d= Hardware Version
U= Intermediate Circuit Voltage in Volt
5
6
A-2
Figure. 30
EN-19
4
Werbung
