OHAUS Frontier FC5513L Bedienungsanleitung Seite 23

EN-18
ATTENTION:
Please notice that you must enter the program as described under point 4.1.2 to change the
adjustments of the points 4.1.3 - 4.1.8. After you have stored the settings, you can change to normal
program mode again by switching off the centrifuge for a short while.
All changed settings must be confirmed by the key "Start"(10). The word "Store" appears in the display
"RPM/RCF"(A-1) - Only then the pre-selections are valid!
4.1.3 Signal turn on / off
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "L" with the adjusting dial (4). As a
result, the words "On Sound" appears in the display "RPM/RCF" (A-1). If you press the key "RPM/RCF" (A-1)
now, the word "On" flashes and you can switch off the sound with the adjusting dial (4) (see figure 29).
After you have stored the settings (see 4.1.2) you change back to the normal program mode again by switching off
the centrifuge for a short while.
A-1
A-1
5
6
TM
Frontier Centrifuge FC5513, FC5513R, FC5513L
Figure. 27
Figure. 28
A-2
Figure. 29
9
7
10
2
4