The Displays - KIENZLE VDO LOGIC PILOT Montage- Und Bedienungsanleitung

The PROG key:
This key is used to select the basic settings, so as to adjust the autopilot for your vessel.
The MODE key:
This key is used to select the various steering modes (COMPASS, WIND, NAV).
The ENTER key:
This key is used to confirm all programming functions and the steering mode selection.

The displays

The analogue display:
The analogue display is in two parts. The current rudder position (RUDDER) is shown in the bottom half of
the dial. When the rudder is set to starboard or port, the pointer moves to the right or left respectively. This
indication is not available when the autopilot is actively steering.
The top half of the dial shows the deviation between the current compass course and the specified course
(OFF COURSE). When the vessel deviates from the specified course to starboard or port, the pointer moves
to the right or left. This indication is only available when the autopilot is activated.
The digital display:
The display shows which steering function is selected.
Example of a display:
During programming of the autopilot, the settings are displayed. Alarms and error messages also appear on
the display.
34
VDO LOGIC PILOT
C - compass 182° - specified course
W - wind
N - navigator
S - Standby / autopilot off
P - autopilot on