Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.3 Unpacking the filter system
After unpacking please check the completeness
of the content and inspect the condition of the
filter system and parts e.g. damages caused by
transport.
i
CAUTION!
• Defect or damaged parts have to be replaced
with original parts from the manufacturer.
• Always ensure a safe and clean working place
• Keep children away from the wrapping
material, risk of suffocation!
For the protection of the environment, dispose
all the plastic waste properly, complying with
local disposal regulations.
6.4 Mounting the wall bracket
i
CAUTION!
• Please check the technical data, operation
and safety instruction before installation.
• Only use hoses according NSF 61 or DVGW W
543 for the connection of the system.
• When mounting the equipment take care of
the installation dimensions (e.g. distances,
necessary radius for the hoses).
Procedure:
1.
The installation should be done at locations
where the connection to the drinking water
supply is as simple and close as possible.
2. The filter system is to be installed and ope-
rated in vertical position (see Fig. 3).
3. To allow service and replacement of the
cartridge after installation a distance of 65
mm between the filter cartidge bottom and
the floor is required.
4. The wall bracket has to be adjusted and
mounted to allow a convenient access and
replacement of the cartridge.
5. The filter system has to be mounted on the
wall firmly and securely.
6. The installation must be done by a professi-
onal and authorized person.
7.
Mark the included label with the installation
date (month/year) and stick the label on top
of the filter head (see Fig. 4).
Fig. 3
Fig. 4
6.5 Mounting the filter head
i
CAUTION!
• Make sure that the filter head is never left
under system pressure over a longer period of
time without any filter cartridge.
• The tightening torque of the fittings must not
exceed 15 Nm!
NOTE!
• The included aqua stop in the filter head
prevents a water flow without installed filter
cartridge.
• Before removing the filter cartridge the sepa-
rately installed valve before the filter system
is to be closed (not included in the scope of
delivery).
Procedure:
1.
Insert the filter head in the wall bracket.
2. Pay attention to the correct direction of the
flow direction (see Fig. 5).
3. Mount and connect the hoses to the filter
head (consider the bending radius of the
hoses; see Fig. 6).
4. Connect the hose to the water supply,
respectively to the valve before the system.
5. Connect the outlet hose of the filter system
to the consumer system/device.
EN
13
Werbung
