Kärcher SC 1125 Plus Bedienungsanleitung Seite 20

Operation
Attaching the Accessories
Tightly insert the steam plug into the ap-
pliance connector. The plug must click
into place audibly.
Connect the required accessories (see
Chapter "Using accessories) to the
steam gun. Insert the open end of the
accessory on the steam gun and push
onto the steam gun until the unlocking
button of the steam gun locks into
place.
Use the extension pieces if necessary.
To do so, connect one or both exten-
sion pieces to the steam gun. Insert the
required accessories on the free end of
the extension piece.
Removing the Accessories
Danger
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!
Push the lock to the front (steam switch
blocked).
To detach the accessory parts, press
the unlocking button and pull the items
apart.
Fill up with water
Note: If you always use usual commercial
distilled water it is not necessary to descale
the boiler.
Caution
Do not use condensation water from the
drier!
Do not fill in detergents or other additives!
Remove the safety cap from the device.
Empty remaining water from boiler.
Fill the boiler with a maximum of 1.2 lit-
ers of fresh tap water.
Note: The boiler can be filled up to
2 cm below the edge of the filler neck.
You can cut down the heating-up time
by using warm water.
Screw the safety cap back onto the de-
vice.
Turning on the Appliance
Place the unit securely on a firm sur-
face.
Note: Do not carry the unit while clean-
ing.
Caution
Do not turn the appliance on without water
in the boiler. Otherwise, the appliance may
overheat (see Help with faults).
Insert the mains plug into a socket.
Press the ON/OFFswitch to turn on the
appliance.
The orange indicator lamp glows.
The orange indicator lamp goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.
– 8
EN 19