Kärcher SC 1125 Plus Bedienungsanleitung Seite 18

Description of the Appliance
See page 3.
A1 Appliance connector with cover
A2 Switch - ON/OFF
A3 Safety cap
A4 Power cord
B1 Indicator lamp (red) - lack of water
steam boiler
B2 Indicator lamp - heater (ORANGE)
C1 Steam gun
C2 Unlocking button
C3 Steam lever locking (child control)
Front – steam lever blocked
Middle – reduced steam amount
Back – maximum steam amount
C4 Steam lever
C5 Steam hose
C6 Steam plug
D1 Detail nozzle
D2 Round brush
E1 Hand nozzle
E2 Terry cloth cover
E3 Micro-fibre abrasive cloth
F1 Steam turbo brush
G1 Extension tubes (two tubes)
G2 Unlocking button
H1 Floor nozzle
H2 Retaining clip
H3 Floor cleaning cloth
K1 Steam iron
K2 Indicator lamp - steam iron heating
K3 Switch - steam ironing
K4 Temperature controller
K5 Steam plug
Safety instructions
Danger
The appliance may not be used in areas
where a risk of explosion is present.
If the appliance is used in hazardous ar-
eas the corresponding safety provisions
must be observed.
Never use the appliance in pools con-
taining water.
The device should not be used to clean
electrical appliances such as oven, ex-
haust, micro-wave, televisions, lamps,
hair-dryer, electrical heating systems, etc.
Check the faultless condition of the ap-
pliance and the accessories before us-
ing it. Otherwise, the appliance must
not be used. Please check in particular
the power cord, the safety lock, and the
steam hose.
If the power cord is damaged, please
arrange immediately for the exchange
by an authorized customer service or a
skilled electrician.
Please arrange for the immediate ex-
change of a damaged steam hose. You
may only use a steam hose that is rec-
ommended by the manufacturer (see
spare parts list for the order number).
Never touch the mains plug and the
socket with wet hands.
Never use the appliance to clean ob-
jects containing hazardous substances
(e.g. asbestos).
Never touch the steam jet from a short
distance with your hands and never di-
rect the steam jet to persons or animals
(risk of scalds).
Warning
The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.
The appliance may only be connected
to alternating current. The voltage must
correspond with the type plate on the
appliance.
In wet rooms, e.g. bathrooms, connect
the appliance to sockets with a series
connected RCD adapter.
– 6
EN 17