F) Deleting A City From The Display List - Conrad DV322 Bedienungsanleitung

Press the button "TEST" again to delete the city from the list; the tick disappears.

If "MEM. FULL" appears, all 5 slots are assigned.
You can save up to 5 cities to display their weather data. To save another city,
you first have to delete an available city from the list (see next chapter).
• Leave setup mode by pressing "SET".

f) Deleting a city from the display list

As described in chapter 12. e), you can save up to 5 cities in different countries and display
their weather forecast with the buttons "?" and "?".
To delete a city from the display list, proceed as follows:
• Select the city you want to delete from the display list with the buttons "" or "".
• Keep the button "SET" depressed (approx. 3 seconds) until "COUNTRY" appears on the
bottom of the display.
• Briefly press the button"". Now the country in which the city to be deleted is located is
displayed.
• Then briefly press the "SET" button.
• Now the display shows "CITY".
• Briefly press the button"". The city is displayed now (observe the small tick mark "√" above
the city).
• Briefly press the "TEST" button on the rear of the weather station. The tick mark "√"
disappears.
• Leave delete mode by pressing "SET".
67