Hitachi CENTRAL STATION PSC-A32MN Installations- Und Betriebshandbuch Seite 62

Operation
5.3.7 Touchscreen Calibration
1 Select "Touchscreen Calibration" at the "Menu" screen.
2 Calibrating touchscreen
• Tap the intersections of white lines in order, as prompted on the screen.
• After that, the display changes to the screen shown in figure (3).
• If the intersections of white lines are not recognized normally, the message "Calibration is cancelled" is displayed on the screen.
And then, and the display returns automatically to the "Monitor (All Groups)" or "Monitor (Block)" screens, without calibrating.
3 "Checking tap position of touchscreen"
• Touch the intersections of white lines in order, as prompted on the screen.
• White dots appear on the screen when tapping in positions other than the intersections of white lines.
• When every intersection of white lines has been recognized normally, the display returns automatically to the "Monitor (All
Groups)" or "Monitor (Block)" screens.
54 PMML0332A rev.0 - 05/2015
(1)
(2)
(3)