Telwin Doctor Charge 50 6-12-24V Bedienungsanleitung Seite 57

LCD DISPLAY (page 2)
1. Battery voltage set.
2. Main display: measured battery voltage, Ah
selected, voltage value set for the SUPPLY,
DIAGNOSTIC, EQUALIZATION programs, interface
messages towards the operator, alarm codes.
3. Alarm for polarity reversal, short circuit, worn or
faulty battery.
4. Current value set, output current measured.
5. Battery charge level.
6. Choice of charge current PULSE- TRONIC: AUTO,
BOOST, Personalised (Ah setting).
7. Charges at low temperatures.
8. Silent operation.
9. EQUALIZATION mode.
10. DESULFATION mode.
11. Choice of battery type:
• WET: Lead-Antimony (PbSb) or Lead-Calcium
(PbCa) or Lead-Calcium Silver (PbCaAg) batteries
with liquid electrolyte.
• EFB
(Enhanced
electrolyte batteries with a higher recharge
capacity and which support a higher quantity of
cycles (start-ups) than traditional ones. Ideal for
vehicles with Start-Stop system.
• GEL: Lead-Calcium (PbCa), solid electrolyte, gel,
completely sealed battery. They are maintenance-
free batteries.
• AGM (ABSORBENT GLASS MAT): lead batteries
with electrolyte absorbed in fibreglass. Completely
sealed. They are maintenance-free batteries.
• AGM+: they ensure a higher number of start-ups
at higher current and more in-depth discharge
than standard AGM. Used on vehicles with Start-
Stop system. Compact dimensions, greater
resistance to vibrations and fast recharge times.
• Lithium (Li): batteries with reduced weight, high
energy density and very low auto-discharge. They
are mainly used in the world of motorsport.
12. SUPPLY mode.
13. DIAGNOSTIC mode.
14. PULSE-TRONIC charge phases.
15. START mode.
16. Automatic charge mode.
17. Charge in PulseTronic.
18. Charging circuit (alternator) functionality testing.
19. Battery self-priming test.
20. Battery charge status test.
21. VOLT - Setting button:
- 6/12/24V battery voltage.
- silent operation.
- voltage/Ah (Decrease).
22. FUNCTION - Setting button:
- PULSE-TRONIC CHARGE (AUTO, AUTO
EFB, GEL, AGM, AGM +, Li).
- TEST (battery status, vehicle alternator, battery
cranking efficiency).
- Advanced
EQUALIZATION, DIAGNOSTIC, SUPPLY).
- voltage/Ah (Increase).
23. MODE - Setting button:
- output current (AUTO, BOOST, personalised).
- START mode.
Flooded Battery):
Programs (DESULFATION,
EN
FUNCTIONS
A. PULSE-TRONIC CHARGE
B. TEST
- CHARGE STATUS TEST
- BATTERY STARTING LOAD EFFICIENCY TEST (CCA)
- ALTERNATOR TEST
C. BATTERY MAINTENANCE
- DESULFATION
- EQUALIZATION
D. POWER SUPPLY
- DIAGNOSTIC
- SUPPLY
E. STARTER AID - START
F. CABLE CALIBRATION
G. SILENT
H. HEALTH TEST
liquid
OPTIONAL
INFO ALARMS
INFO FIRMWARE
CHARGER CABLES CONNECTION
SWITCH ON
, WET,
- 57 -
SWITCH OFF
230V - 1ph
50/60 Hz
230V - 1ph
50/60 Hz