Werbung
Verfügbare Sprachen
Verfügbare Sprachen
74
MS-1
MS-1 Parameters Select
CHANGING THE PARAMETERS
The parameters may be changed using the following procedure:
1.
Press SHIFT+ HOLD/REST + 8 to enter the setting mode. The LOCATION LED 1 will blink yellow.
2.
Press <KYBD or STEP> to select pages 1 to 5. The yellow LOCATION LED, shows the current page:
3.
Page 1 allows you to select the MIDI input channel, 1 to 16.
4.
Page 2 allows you to select the MIDI output channel, 1 to 16.
5.
Page 3 allows you to select the clock source mode from 1 to 5: (INTERNAL / MIDI DIN / MIDI USB / TRIG / AUTO). When using AUTO, the clock priority is:
TRIG > MIDI USB > MIDI DIN > INTERNAL
6.
Page 4 allows you to select the clock type mode, 1 to 4: (1PPS / 2PPQ / 24PPQN / 48PPQN)
7.
Page 5 allows you to select the clock edge mode, 1 to 2: (Fall / Rise)
8.
Press STEP switches 1 to 8 to select numeric values from 1 to 8. The current value is indicated by a green LOCATION LED.
9.
To access values 9 to 16, press SHIFT + STEP switch 1 to 8. The current value is shown by a red LOCATION LED.
Note: If a setting is on the same LED number as the current page LED, then the LED will flash alternately between the yellow page color and the green or red
parameter color.
10.
Press SHIFT + HOLD/REST + 8 to exit the setting mode, and save any parameter changes.
11.
More parameters can be changed using the Synthtool App.
ADSR Envelope
The stages of the ADSR envelope are shown in this simplified diagram
below. The envelope can control the VCA level, the VCF cut-off frequency,
and Pulse Width modulation of the VCO.
Attack
Decay
Time
Time
Env
Level
Sustain Level
Key
Gate
Key Pressed
Key Released
Release
Time
Time
Werbung
