ELCOM RTD112Y Anleitung Seite 47

RTD112Y
Applications
APPLICATION N° 7: SIP relay command via HTTP
request
The SIP relay is used as a switching device (latch, lighting, etc.).
The SIP relay is switched on receipt of an HTTP request. This function can be
performed in conjunction with another application. A connection/call (commu-
nication) is not needed to control the SIP relay. The activation duration of relays
K1 and/or K2 can be set in the SIP relay configuration.
Configuration:
On to the ISS-300 intercom SIP server, retrieve the parameters for accessing
the SIP relay from the main network (IP address +port).
www.elcom.de
SUBNET

K1
To control relay 1 (K1), type the command: "IPaddress:port/relay.cgi&1
remoteauthcode" in the browser using the format given and validate.
To control relay 2 (K2), type the command: "IPaddress:port/relay.cgi&2
remoteauthcode" in the browser using the format given and validate.
Remark:
"Remoteauthcode" must correspond to the value given when the SIP relay was
configured (Expert configuration, System tab, Authentication code field).
Subject to technical changes
ISS-300
HTTP request - K2
K2
HTTP request - K1
MAINNET
47