Toro eHoverPro 450 Bedienungsanleitung Seite 25

Problem
The LED indicator light on the battery
charger is blinking red.
Machine Operation
Problem
The machine or motor vibrates excessively
The machine is producing a beeping
sound.
Quality of Cut
Problem
The quality of cut is decreased or
unsatisfactory.
There is an uneven cutting pattern
The machine is cutting unevenly.
Possible Cause
1. There is an error in the communication
between the battery pack and the
charger.
2. The battery pack is weak.
Possible Cause
1. The underside of the machine housing
contains clippings and debris.
2. The motor mounting bolts are loose.
3. The blade bolt is loose.
1. The battery pack is not charged.
2. The machine is overloaded.
3. There is another electrical problem
with the machine.
Possible Cause
1. The blade is dull.
2. The cutting deck has debris buildup.
1. You are cutting in the same pattern
repeatedly.
2. The underside of the machine housing
contains clippings and debris.
1. The blade is dull.
2. You are cutting in the same pattern
repeatedly.
3. The underside of the machine housing
contains clippings and debris.
4. There is an electrical problem with the
machine.
23
Corrective Action
1. Remove the battery pack from the
battery charger, unplug the battery
charger from the outlet, and wait 10
seconds. Plug the battery charger into
the outlet again and place the battery
pack on the battery charger. If the LED
indicator light on the battery charger is
still blinking red, repeat this procedure
again. If the LED indicator light on
the battery charger is still blinking red
after 2 attempts, properly dispose of
the battery pack at a battery recycling
facility.
2. Properly dispose of the battery pack at
a battery recycling facility.
Corrective Action
1. Clean under the machine housing.
2. Tighten the motor mounting bolts.
3. Tighten the blade bolt.
1. Remove the battery pack from the
machine and charge it.
2. Cut the grass at a higher height of cut
or walk at a slower pace while mowing.
3. Attempt the other troubleshooting
actions, if the alarm still sounds,
contact an Authorized Service Dealer.
Corrective Action
1. Have the blade sharpened or replaced.
2. Clean under the machine.
1. Change the cutting pattern.
2. Clean under the machine housing.
1. Have the blade sharpened or replaced.
2. Change the cutting pattern.
3. Clean under the machine housing.
4. Contact an Authorized Service Dealer
or authorized Toro distributor.