Toro eHoverPro 450 Bedienungsanleitung Seite 10

Setup
1
Installing the Handlebar
Footstop
Parts needed for this procedure:
1 Lower handlebar
1 Footstop
1 Bolt (6 x 35 mm)
3 Washer (6 mm)
1 Locknut (6 mm)
Procedure
Note:
You can only use the footstop to support the
handlebar in the vertical position when you assemble
the handlebar in the lower position 103.4 cm (40-3/4
inches).
1. Low-handlebar position
2. Upstop bracket
Figure 3
3. Footstop
4. High-handlebar position
1. Determine the handlebar height when the
footstop is secured to the upstop bracket
3).
2. Align the hole in the footstop with the hole in the
lower handlebar
1. Lower handlebar
2. Footstop
3. Bolt (6 x 35 mm)
3. Assemble the footstop to the handlebar with a
bolt (6 x 35 mm), 3 washers (6 mm), and locknut
(6 mm).
4. Tighten the locknut and bolt.
Note:
Ensure that you can pivot the footstop.
g414363
8
(Figure 4).
Figure 4
4. Washer (6 mm)
5. Locknut (6 mm)
(Figure
g364679