Toro eHoverPro 450 Bedienungsanleitung Seite 19

Operating Tips
General Mowing Tips
•
Place the hoop of the footstop under the upstop to
increase handling of the machine.
Figure 25
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to
vibrate, immediately shut off the motor, remove
the electric-start key, and examine the machine
for damage.
•
For best performance, ensure that the blade is
sharp before the cutting season begins.
•
Replace a damaged blade with a new Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
Do not cut below the highest setting (30 mm or
1-1/4 inches) unless the grass is sparse, or it is
late fall when grass growth begins to slow down.
•
Do not mow grass over 15 cm (6 inches) long
because the machine may plug or the motor may
stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the motor to
stall. Mow only in dry conditions if possible.
WARNING
Wet grass or leaves can cause serious
injury if you slip and contact the cutting
blade.
Mow only in dry conditions if possible.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
•
If the finished lawn appearance is unsatisfactory,
try 1 or more of the following:
– Inspect the cutting unit and/or replace the
cutting blade.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
Cutting Leaves
g367278
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
•
Mowing grass over 15 cm (6 inches) in length is
not recommended. If the leaf cover is too thick, the
machine may plug and cause the motor to stall.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.
After Operation
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only at an
ambient temperature that are within the specified
temperature range; refer to
and Storage Temperature Ranges (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Ensure that the vents on the battery and charger
are clear of any dust and debris.
17
Charging, Operation,
12).