Toro eHoverPro 450 Bedienungsanleitung Seite 13

3. Insert the end of the operator-presence bail into
the handlebar, squeeze the other leg of bail
slightly, and insert the bail into the handlebar
(Figure 11).
Installing the Electric-Start Switch
1. Insert the push-in fastener into the hole in the
upper handlebar as shown in
Figure 12
1. Hole (upper handlebar)
2. Above the push-in fastener, assemble the
electric-start switch onto the handlebar
13).
Figure 11
Figure 12.
2. Push-in fastener
1. Pan-head screw
2. Electric-start switch
3. Upper handlebar
g367358
4. Cable (operator-presence
bail)
3. Align the cable for the operator-presence bail
to the upper cable groove of the electric-start
switch.
4. Align the cable clamp to the cable and switch.
5. Secure the clamp, cable, and switch to the upper
handlebar with the pan-head screw, washer, and
locknut.
g367912
(Figure
11
Figure 13
5. Cable clamp
6. Washer
7. Locknut
g367911