Toro eHoverPro 450 Bedienungsanleitung Seite 22

1. Conical spacer
2. Spacers
3. Blade
4. Use a block of wood to hold the blade steady
(Figure 30).
5. Use the wrench provided with the machine to
remove the blade by rotating the blade bolt
counterclockwise
Important:
Wear safety glasses and cut
resistant gloves when removing the blade.
Installing the Blade
1. Align the curved ends of the blade toward mower
deck, and assemble the retainer, blade, spacers,
and conical spacer to the impeller with the bolt.
Important:
You must always assemble the
conical spacer directly below the impeller
and the retainer under the head of the bolt.
Figure 29
4. Retainer
5. Bolt
Figure 30
(Figure 29).
1. Impeller
g364990 2. Conical spacer
2. Torque the blade bolt to 75 N∙m (55 ft-lb).
Important:
is very tight. While holding the cutting blade
with block of wood, put your weight behind
the torque wrench, and tighten the bolt.
g364888
3. Tip the machine upright.
20
Figure 31
3. Retainer
4. Bolt
A bolt torqued to 75 N∙m (55 ft-lb)
Figure 32
g364923
g364889