Toro eHoverPro 450 Bedienungsanleitung Seite 20

Figure 26
1. Battery pack cavity
2. Battery pack venting areas 7. Charger LED indicator
3. Battery pack electrical
contacts
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
2. Line up the cavity in the battery pack
with the tongue on the charger.
3. Slide the battery pack into the charger until it is
fully seated (Figure
4. Wait for the battery pack to charge; refer to
the following Battery Charger Status Table to
interpret the battery charger status.
Battery Charger Status Table
LED Indicates
indicator
light
Off No battery pack is inserted
Battery pack is charging
Green
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the specified temperature range*
Red Battery pack charging fault**
blinking
*Refer to Charging, Operation, and Storage Temperature
Ranges (page 12) for more information.
**Refer to Troubleshooting (page 22)
Important:
The battery can be left on the
charger for short periods between uses.
If the battery will not be used for longer
periods, remove the battery from the charger;
refer to Preparing the Machine for Storage
(page 21).
6. Handle
light
8. Charger venting areas
9. Adapter charger
(Figure
26).
for more information.
5. To remove the battery pack, pull the battery from
the charger.
g290533
26)
18