Toro eHoverPro 450 Bedienungsanleitung Seite 21

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
After each use
Yearly
Preparing for Maintenance
1. Move the machine to a level surface.
2. Shut off the machine, remove the electric-start
button, and remove the battery; refer to
Off the Machine (page
Blade Maintenance
WARNING
When servicing the blade, the blade can still
move even though the power source is off.
The blade is sharp; contacting the blade can
result in serious personal injury.
• Keep your hands and feet away from a
moving blade.
• Wear gloves when servicing the blade.
Checking the Blade
Service Interval: Before each use or daily If the blade
is damaged, replace it immediately.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Tip the machine onto its side.
Figure 27
Maintenance Procedure
• Check the blade for wear or damage. If the blade is damaged, replace it immediately.
• Clean grass clippings and dirt from the entire machine.
• Clean grass clippings and dirt from the entire machine.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
Shutting
14).
19).
g414372
3. Check the blade for wear or damage.
•
If the blade is damaged or cracked, remove
and replace it immediately.
•
If the blade edge is dull or nicked, remove
it, have it sharpened or replaced, and install
the blade.
4. Tip the machine upright.
Replacing the Blade
Service Interval: Yearly
Important:
You need a torque wrench to
install the blade. If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorized Service Dealer
or authorized Toro distributor.
Removing the Blade
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Tip the machine onto its side.
3. Record the position of the spacers.
19
19).
Figure 28
g414372