Toro eHoverPro 450 Bedienungsanleitung Seite 17

Removing the Battery Pack from the Machine
1. Shut off the machine; refer to
2. Open the battery-compartment cover
3. Press the battery-pack latch to release the battery pack and remove the battery pack.
4. Close the battery-compartment cover.
Supporting the Handlebar
with the Footstop
Handlebar Assembled in the
Lower Position
Note:
If you assembled to the low-handlebar position
103 cm (40-1/2 inches), use the footstop to support
the handlebar in the vertical position
Figure 19
1. Footstop rotated forward
•
To release the handlebar, lift the handlebar and
rotate the footstop forward
•
To support the handlebar, position the handlebar
and rotate the footstop rearward.
Shutting Off the Machine (page
(Figure
g367257
2. Footstop rotated rearward
(Figure 19).
14).
18).
Figure 18
Adjusting the Cutting
Height
WARNING
Adjusting the cutting height may bring you
into contact with the moving blade, causing
serious injury.
• Release the operator-presence bail and
wait for all moving parts to stop.
• Wear cut-resistant gloves while handling
the blade.
Removing the Blade
1. Shut off the machine, remove the electric-start
button, and remove the battery; refer to
Off the Machine (page
2. Tip the machine on its side.
3. Use a block of wood to hold the blade steady
(Figure 21).
15
14).
Figure 20
g414370
Shutting
g414372