Toro eHoverPro 450 Bedienungsanleitung Seite 24

Troubleshooting
Perform only the steps described in these instructions. Have an Authorized Service Dealer or authorized Toro
distributor complete all further inspection, maintenance, and repair work if you cannot fix the problem.
Battery Pack
Problem
The machine does not start.
The machine does not run continuously.
The machine does not reach full power.
The battery pack loses charge quickly.
Battery Charger
Problem
The battery charger is not working.
The LED indicator light on the battery
charger is red.
Possible Cause
1. The battery pack is not fully installed
in the machine.
2. The battery pack is not charged.
3. The battery pack is damaged.
4. There is another electrical problem
with the machine.
1. There is moisture on the leads of the
battery pack.
2. The battery pack is not fully installed
into the machine.
1. The battery pack charge capacity is
too low.
2. The air vents are blocked.
1. The battery pack is over or under the
specified temperature range.
Possible Cause
1. The battery charger is over or under
the specified temperature range.
2. The outlet that the battery charger is
plugged into does not have power.
1. The battery charger and/or battery
pack is over or under the specified
temperature range.
22
Corrective Action
1. Remove the battery pack and then
install it into the machine, making sure
that it is fully inserted and latched.
2. Remove the battery pack from the
machine and charge it.
3. Replace the battery pack.
4. Contact an Authorized Service Dealer
or authorized Toro distributor.
1. Allow the battery pack to dry or wipe it
dry.
2. Remove the battery pack and then
install it into the machine, making sure
that it is fully inserted and latched.
1. Remove the battery pack from the
machine and fully charge the battery
pack.
2. Clean the air vents.
1. Move the battery pack to a place
where it is dry, and the temperature is
between 5°C (41°F) and 40°C (104°F).
Corrective Action
1. Unplug the battery charger and move
it to a place where it is dry, and the
temperature is between 5°C (41°F)
and 40°C (104°F).
2. Contact your licensed electrician to
repair the outlet.
1. Unplug the battery charger and move
the battery charger and battery pack
to a place where it is dry, and the
temperature is between 5°C (41°F)
and 40°C (104°F).