Toro eHoverPro 450 Bedienungsanleitung Seite 11

2
Installing the Handlebar
Parts needed for this procedure:
4 T-bushings
2 Bolt (6 x 55 mm)
7 Washer (6 mm)
2 Locknut (6 mm)
1 Upper handlebar
2 U-bolt
2 Knob
1 Push-in fastener
1 Pan-head screw
1
Cable clamp
1 Washer
1 Locknut
Assembling the Lower Handlebar
to the Machine
1. Assemble 2 T-bushings into the handlebar
flanges of the mower deck
1. T-bushings
2. Align the footstop of the handlebar to the up-stop
bracket on the deck
(Figure 5).
Figure 5
2. Handlebar flanges (mower
deck)
(Figure 6).
1. Up-stop bracket
3. Align the hole in the handlebar with the holes in
the bushings
to the machine with a bolt (6 x 55 mm), 2
washers (6 mm), and a locknut (6 mm).
g367117
1. Lower handlebar
2. Bolt (6 x 55 mm)
4. Repeat step
Assembling the Upper and Lower
Handlebars
1. Align the holes on the upper handlebar with the
holes in the lower handlebar
9
Figure 6
2. Footstop
(Figure 7), and secure handlebar,
Figure 7
3. Washer (6 mm)
4. Locknut (6 mm)
3 at the other side of the machine.
(Figure
g414364
g367302
8).